Horizon Fitness BOOK BINDER BQ-470 Important Information Manual page 175

5-14 Replacing the Glue
Install the side glue drain.
(1) Loosen the two drain mounting screws.
(2) Insert the side glue drain on the screws, and
tighten both the left and right screws.
Place a disposal container under the glue
drain.
WARNING
Use a container for the glue that will not
be damaged by the heat of the glue. This
can be dangerous if the container tears or
cracks.
Pull out the drain plug using a 14 mm or
0.55" hex wrench.
• If the plug is pulled out suddenly, a lot of
glue will rush out. Remove the plug
slowly.
• Any glue on the side glue drain can be
peeled off when it cools. Leave the glue
standing until it cools off.
• If the glue has been hardened
completely, the plug cannot be installed.
Go to the next step before hardening of
glue.
Install the plug, and remove the side glue
drain.
Pull out the tank unit.
Mount the front cover, and return the tank
unit to its original position.
For more information see steps
Section 3-2-1.
Add fresh glue.
Side Glue Drain
Tank Unit
and in
5-14-2
Replacing the side glue
Loosen this screw and
insert the side glue drain.
Disposal Container
Remove the drain plug
slowly.
Tighten the four
mounting screws.
Front Cover
Return the tank unit to its original
position, and tighten up the locking
knob again.
22064
51002B1
5
22064
51002D1
Tighten
22064
51002F1
165