4-4
Cover-Related Problems
4-4-3 The covers move in the top/bottom direction on the book
blocks
Where to check
The cover tail edge
positioner is set to
the wrong position.
Cover is not stopped
at the correct
position at the
nipping section.
4-4-4 There are variations in the cover adhesion position
Where to check
The cover jog guide
widths are too wide
or too narrow.
The spacer is
installed with the
carninge clamp.
The book block are
bent.
Cause and solution
• Adjust the cover tail edge positioner in the
left/right direction using the Bookbinding -
Fine-Tune Adjustment - Covers screen.
–
+
22064
40403B1
• Use the accessory cover stopper. Test feed
Cover Stopper(F)
the cover sheet and set the magnet stopper
at the suitable position on the jog guide.
Cover Stopper(R)
22064
40401C1
Cause and solution
• Adjust the widths of the cover jog guides
using the Bookbinding - Fine-Tune
Adjustment - Covers screen.
22064
40404A1
• To hold the lower position of the book block,
Spacer
insert the spacer (accessory) between the
clamp and support plate. Install these
spacers.
22064
40404B1
• Straighten any bent or carled book block.
Book Block
22064
40404C1
22064
40403A1
Related
item
1-3-2
—
4
Related
item
1-3-2
5-10
-
111