4-7
Problems with the Main Part of the Machine
4-7-9 Scattered trim
Where to check
The trim bag is full or
the filter bag is
clogged.
The milling brushes
are worn.
The trim is clogging
the hose.
Trim is clogging the
area around the
milling cutter.
The circuit breaker
for the milling blower
has tripped.
124
Cause and solution
• Throw out the trim.
• If the filter bag is clogged, clean it.
Clean
Throw
out
22064
40708A1
• If the milling brushes are worn, replace the
milling brushes.
12076
40708E1
• Turn the power switch off, and then remove
the rear cover.
• Loosen the hose clamp, disconnect the
hose, and remove any trim which is clogging
the hose.
22064
40708B1
• Turn the power switch off, remove the front
and rear milling guides, and clean away any
trim which has accumulated around the
milling cutter.
22064
40708C1
• Check whether the circuit breaker has
(1)
tripped.
• If the circuit breaker trips again, place a
service call.
Press
22064
40708D1
WARNING
Use work gloves for this job, and
be careful not to touch the edges
of the milling cutter or the
notching cutter blades. The sharp
edges on the blades may cut you.
Related
item
5-5
5-23
—
—
5-17