Omron OMNUC R88D-WT15HF User Manual page 465

Appendix
Parameter Parameter
Parame- Parame-
name name
ter No. ter No.
Digit
No.
Pn50A Input signal 0
selection 1
1
2
3
Pn50b Input signal
0
selection 2
1
2
3
6-24
Explanation (See note 1.)
Name Set- Explanation (See note 2.)
ting
Input signal
0 Sets the sequence input signal
allocation allocation to the same as
mode
R88D-UT.
1 User-defined sequence input
signal allocation
RUN signal 0 Allocated to CN1, pin 40: Valid
(RUN (
at low input.
command) d)
1 Allocated to CN1, pin 41: Valid
input
at low input
terminal terminal
allocation 2 Allocated to CN1, pin 42: Valid
at low input
3 Allocated to CN1, pin 43: Valid
at low input
4 Allocated to CN1, pin 44: Valid
at low input
5 Allocated to CN1, pin 45: Valid
at low input
6 Allocated to CN1, pin 46: Valid
at low input
7 Always enabled.
8 Always disabled.
9 Allocated to CN1, pin 40: Valid
at high output
A Allocated to CN1, pin 41: Valid
at high output
b Allocated to CN1, pin 42: Valid
at high output
C Allocated to CN1, pin 43: Valid
at high output
d Allocated to CN1, pin 44: Valid
at high output
E Allocated to CN1, pin 45: Valid
at high output
F Allocated to CN1, pin 46: Valid
at high output
MING signal 0 to F Same as Pn50A.1.
input
MING (gain reduction) signal
terminal
allocation
allocation
POT signal 0 to F Same as Pn50A.1
input
POT (forward drive prohibited)
terminal
signal allocation
allocation
NOT signal 0 to F Same as Pn50A.1.
input
NOT (reverse drive prohibited)
terminal
signal allocation
allocation
RESET 0 to F Same as Pn50A.1.
signal input
RESET (alarm reset) signal
terminal
allocation
allocation
PCL signal 0 to F Same as Pn50A.1.
input
PCL (forward rotation current
terminal
limit) signal allocation
allocation
NCL signa 0 to F Same as Pn50A.1.
input
NCL (reverse rotation current
terminal
limit) allocation
allocation
Chapter 6
Default Default Unit Unit Setting Setting
setting setting range range
8100 --- ---
6548 --- ---
Restart Restart
power? power?
Yes
Yes