Omron OMNUC R88D-WT15HF User Manual page 280

Operation
there are no Pn006 to Pn099). For this reason, if, for example, you change Pn000 to Pn207 using the
Shift Key, you can perform the operation more quickly by making the change starting from the leftmost
digit side (i.e., digit No. 2).
D Displaying Parameter Settings
PR02W Front panel
operation key operation
(1 s min.)
Note Parameter settings can be displayed as 5 digits as shown above, or as "n." followed by 4 digits,
i.e., as n.jjjj.
D Changing Settings
• The following operation is not necessary if you are only checking the settings.
• Parameter settings can be set as 5 digits, or as 4 digits (displayed as n.jjjj). When set as 4 digits,
each digit in the parameter has a meaning, so the parameter cannot be set just by using the Up and
Down Keys. Be sure to set the parameter using the Left Key (front panel: DATA Key for less than 1 s),
and Right Key.
Types of parameters
Function selection switches (Pn000 to
Pn003)
Speed control setting (Pn10b)
Online auto-tuning setting (Pn110)
Position control settings 1 to 3 (Pn200,
Pn207, Pn218)
Torque command setting (Pn408)
I/O signal selection (Pn50A to 513)
All other user parameters
Example of a 5-digit Parameter Setting
PR02W Front panel
operation key operation
(less than
1 s)
Display example
(The parameter number is displayed.)
Press the DATA Key (front panel: DATA Key for 1 s min.)
to display the parameter setting.
Display example
Display example
(Present setting)
Change the setting using the Up or Down Key. If the
setting is too large, you can set the operation to be
performed more quickly while changing the operation
digits, using the Left Key (front panel: DATA Key for less
than 1 s) or Right Key.
Explanation
Explanation
For parameters displayed as
"n.jjjj", each of the 4 digits after
the "n." indicate different function
settings (i.e., 4 different function
settings are performed using 1
parameter No.) For these parameters,
each digit must be set separately.
Parameters displayed using 5 digits
indicate a single value. These
parameters can be set from the lowest
point to the highest point within the
setting range using just the Up or Down
Key. You can also set the digits
separately.
Explanation
Chapter 4
4-17