Functions Added In Multi Program 2 Mode - Sony MVS-8000SF User Manual

For details, see "Settings in the Timeline Menu" in Chapter 13 (Volume 2).
Enabling re-entry between the main and sub sides of the same
M/E bank
In the Engineering Setup >Switcher >Config menu, set [MP2 Free Re-Entry]
to On.
Notes
• Re-entry adds a 1H delay to the video. Nested re-entry may lead to problems
in the video.
• A maximum of eight re-entry stages are possible, with the final output having
a delay of 4H.
• The selection order of re-entry signals affects the number of lines by which
the output signal is lowered.
• If a delay occurs in the image, even when the through mode is set, the
ancillary data does not pas through.
• For example, it is possible to select the re-entry of M/E-1 main on M/E-1
main.
Restrictions on Mutual Re-entry When Using Multi Program 2
The snapshot function is affected by this re-entry function.
When the [MP2 Free Re-Entry] button is On, and any of the switcher banks are
in Multi Program 2 mode, then the following restrictions apply.
If you save and recall snapshots simultaneously with more than one region
specified, the recorded state is played back in the order of precedence of
regions (M/E-1 >M/E-2 >M/E-3 >P/P). Therefore, if you save and recall
snapshots with more than one region specified, the cross-point settings may not
be recalled correctly.
To recall the snapshots correctly, press the cross-point button before recalling
the snapshots, to select a signal other than the re-entry signal, then recall the
snapshots.

Functions Added in Multi Program 2 Mode

• You can set video processing for the utility 3 bus signal.
• In the control panel and DCU GPI input settings and switcher GPI link
settings, the actions that can be selected now also include "Sub Cut" and
"Sub Auto Trans."
• A switcher GPI link can now be set also for the utility 3 bus.
• To the macro event configuration parameters and macro attachment settings,
"Main & Sub" and "Sub" have been added.
419
Multi Program 2