Specifying The Key Output Destination - Sony MVS-8000SF User Manual

Lit amber: Shows the DME assigned to a key other than the currently
selected key.
Off: DME is not assigned.
To select a DME being used by another keyer
Press [Override], turning it on, then select the DME channel.
The later selection is valid, and the button lights green.
You can check the DME operating status in the Status menu (see page 376).
Selecting the video signal for the DME assigned to a key
For the operating procedure, see"Selecting the video signal for a DME
assigned to a key" (page 198).
Assigning a DME output signal as a monitor signal
1
In the Processed Key menu, press [Monitor].
The Monitor menu appears.
2
Press [Monitor Set], turning it on.
3
In the <DME Select> group, select the DME channel (DME1 to DME8) to
be used.
This assigns the selected DME output to DME MON V and DME MON K.
The colors with which [DME1] to [DME8] are lit show the key assignment
status.
Lit green: DME currently being monitored
Lit amber: DME that can be monitored
Off: Unassigned DME

Specifying the Key Output Destination

Using the key processed keyer signals (external processed key)
To select the key processed keyer key fill and key source signals on the AUX
bus or edit preview bus, press [Ext Proc Key] turning it on, in the Processed
Key menu.
This assigns the key fill and key source signals for M/E-1 key 1 to reentry
signals PROC V and PROC K.
When a DME is selected on the keyer, the key fill and key source signals to
which a DME effect is applied are assigned.
Key Setting Operations Using Menus
193