Sony MVS-8000SF User Manual page 437

Notes
When [FM Link] is On, frame memory output does not include ancillary
data for the right image.
5
Repeat steps 3 and 4, to set all of the frame memory outputs for 3D mode.
Functions for which left and right frame memory outputs are
coupled when [FM Link] is On
Pair mode On/Off, clip playback, clip transition
Carry out operations other than the above separately for left and right.
1) When [FM Link] is On, a clip for the right frame memory to be used in the clip transition cannot
be selected in the following menus.
• M/E-1 >Misc >Transition >Clip Transition >Clip menu
• M/E-2 >Misc >Transition >Clip Transition >Clip menu
• P/P >Misc >Transition > Clip Transition > Clip menu
The selection must be made in the Frame Memory >Clip >Recall menu
Switching the type of DME output signal (video/key) assigned to
a monitor signal
This operation is the same as for a dual link.
For details, see "Switching the signal type of DME output (video/key) assigned
to a monitor signal" (page 429).
Selecting the signal output from a DME monitor output
connector
1
Display the Engineering Setup >DME >Output >Monitor Output menu.
2
Press [DME1] or [DME2] to select the DME to operate on.
3
On the left, select MONI OUT#1 or MONI OUT#2.
4
On the right, select the signal.
You can select any of Ch1 Video, Ch1 Key, Ch2 Video, and Ch2 Key.
5
Press [Set].
This assigns the signal.
1)
, clip transition snapshot
3D Support
437