Sony MVS-8000SF User Manual page 708

[START TC] button: Set the start point of the keyframe point to the current
[STOP TC] button: Set the stop point of the keyframe point to the current
[SET START TC] button (of the search dial module, option): Enable to
[SET STOP TC] button (of the search dial module, option): Enable to input
[SET DUR] button (of the search dial module, option): Enable to input the
[CUE] button: Cue up to the start point set for the keyframe point.
To display or check the settings, use the Device >DDR/VTR >Timeline menu.
To test an action command output
To test an action command output, select the desired device from the upper list
in the status area, and press [Test Fire].
An action command is output from the DCU 9-pin serial port, according to the
settings in the list.
To clear the start point, stop point, and variable speed settings
1
2
To set the action for a rewind operation
On the VTR/disk recorder/Extended VTR timeline, when the [REWIND]
button in the keyframe control block is pressed the action set for the first
keyframe is not executed; when the [RUN] button is pressed, then the first
keyframe action is executed.
To execute an action when the [REWIND] button is pressed, it is necessary to
set this action (Rewind Action). To carry out this setting, in the Device >DDR/
VTR >Timeline menu, press [Rewind Action] to recall the Rewind Action
menu. In this setting screen, use the same setting method as in the screen for
setting an action on the VTR/disk recorder timeline.
708
Control of VTRs, Extended VTRs, and Disk Recorders
time.
time.
input the timecode of the start point of the keyframe point with the numeric
keypad control block.
the timecode of the stop point of the keyframe point with the numeric
keypad control block.
duration between the start point and stop point of a keyframe point with the
numeric keypad control block.
In the upper list in the status area, select the device for which you want to
clear the settings.
Carry out any of the following operations as required.
• To clear the start point setting, press [Clear] in the <Start TC> group.
• To clear the stop point setting, press [Clear] in the <Stop TC> group.
• To clear the variable speed setting, press [Clear] in the <Variable
Speed> group.