Side Flags; Overview; Side Flag Settings - Sony MVS-8000SF User Manual

Side Flags

Overview

The term "side flags" refers to the areas to left and right of an image with aspect
ratio 4:3 embedded within a 16:9 frame, when these areas are filled with a
separate image selected from the utility 1 bus.
You can adjust the width of the side flag area.
Notes
The side flag function is only supported on the MVS-8000A/8000G.

Side Flag Settings

Input source aspect ratio, auto side flags, and auto crop settings
Aspect ratio 4:3 setting
Set the input signal to aspect ratio 4:3. If set to 16:9, the side flags are disabled.
Auto side flag setting
This function automatically applies side flags when a 4:3 signal is selected in
the cross-point control block.
Auto crop setting
When carrying out a DME wipe, this function automatically crops the image
during transition to 4:3.
Adjusting the width of the side flag area
You can set the left and right sides separately.
For the operation for the above setting, see "Settings for Switcher
Configuration (Config Menu)" in Chapter 20 (Volume 3).
Enabling and disabling side flags with a menu operation
You can enable or disable side flags for the backgrounds (A and B) of each of
the M/E and PGM/PST banks.
As an example, to enable side flags for background B row on the M/E-1 bank,
use the following procedure.
404
Side Flags