Sony MVS-8000SF User Manual page 179

Hide thumbs Also See for MVS-8000SF:

Table of Contents

• Carrying out a [KEY] button operation in the AUX bus control block

requires the [KEY] button operating mode (Key Source Bus Select

Mode) to be set. With the factory default setting (Key), the [KEY] button

is always off, and it is only possible to select a key signal assigned to a

button as the key source signal.

For details, see "Operation Settings (Operation Menu)" in Chapter 19

• On the MVS-8000, the video signal selection operation is not supported.

• When [Split] is selected, the key memory function (see page 165) is

To select a video signal assigned to a cross-point button

By selecting the key source bus with an auxiliary bus control block AUX

delegation button, and pressing the cross-point button, it is possible to select

the video signal assigned to the cross-point button.

(If you press the cross-point button with holding down [KEY], the key signal

assigned to the cross-point button.)

In the above operation, the following settings must have been made.

• Assigning the key source bus to an AUX delegation button

For details, see "Auxiliary Bus Control Block Settings (Aux Assign Menu)"

in Chapter 19 (Volume 3).

• Setting the [KEY] button operating mode

For details, see "Operation Settings (Operation Menu)" in Chapter 19

This operation is not supported on the MVS-8000.

Selecting key source and key fill in the menu

Selecting key source

For example, to select the key source for M/E-1 key 1, use the following

In the M/E-1 >Key1 >Type menu, press [Signal Select].

The Signal Select menu appears.

Key Setting Operations Using Menus