Table of Contents
Advertisement
Digital Multi Effects (DME)
DME allows you to add three-dimensional effects such as image movement,
rotation, magnification and shrinking, as well as a wide variety of special
effects. DME is the general name for all of these effects.
You can use up to eight channels as dedicated DME channels. Each channel
can be used on its own or in combination with other channels, which allows
you to create advanced effects with more complexity.
Note
To carry out DME wipes requires the BKDS-9470 DME Board Set or the
MVE-8000A/9000 DME Processor.
Functions that can be used differ with the models of DME. For details, see
"Functional Differences With Models of DME" in the Appendix (Volume 2).
MVE-8000A Multi Format DME Processor
The MVE-8000A is a "Digital Multi Effects" with multi-format support.
To connect the DME to a DVS-9000 series switcher, install an optional MKE-
8021A Input/Output Board in the MVE-8000A and use an SDI interface.
Note
When using the SDI interface, the following operations are required.
• You must set the input signals from the switcher to the MVE-8000A (AUX
bus outputs), and signals returned to the switcher as primary inputs (reentry
inputs). However, "Ext In" cannot be set for the DME channel.
See "Setting the AUX bus output and reentry input" in Chapter 16 (Volume
2).
• Select the combiner channels not in the key control block, but in the Global
Effect menu.
See "Combiner Settings" in Chapter 11 (Volume 2).
MVE-9000 Multi Format DME Processor
The MVE-9000 is a "Digital Multi Effects" with multi-format support.
Use the SDI interface to make connections to a DVS-9000 series switcher.
Notes
• Using the MVE-9000 requires the following operations.
– "Setting the interface between the DME and the switcher" (see Chapter 16
94
Digital Multi Effects (DME)
(Volume 2))
Advertisement
Table of Contents
