Sony MVS-8000SF User Manual page 279

Display indications when multiple channels are selected at the same
time
The indications on the knobs show the settings of the lowest-numbered
channel. When you turn the knobs to adjust the settings, this changes the
settings on the other channels by the same amount.
Setting the DME wipe position (Positioner)
1
In the M/E-1 >DME Wipe menu, select HF5 'Modify.'
The Modify menu appears.
2
Depending on whether the DME wipe pattern is in one-channel mode or
two-channel mode, proceed as follows.
For a pattern in one-channel mode: press [1st Ch], turning it on.
For a pattern in two-channel mode: from the <Ch Select> group, select
the corresponding channel. You can select more than one channel at
the same time.
3
In the <Position> group, press [Position], turning it on.
4
Set the following parameters.
Knob
1
2
Display indications when multiple channels are selected at the same
time
The indications on the knobs show the settings of the lowest-numbered
channel. When you turn the knobs to adjust the settings, this changes the
settings on the other channels by the same amount.
To return the DME wipe pattern position to the center of the screen
In the <Position> group, press [Center].
Displaying and moving the position of the DME wipe pattern
(position select)
1
In the M/E-1 >DME Wipe menu, select HF5 'Modify.'
The Modify menu appears.
Parameter Adjustment
H Horizontal position
V Vertical position
Setting values
–200.00 to +200.00
–200.00 to +200.00
Basic Procedure for DME Wipe Settings
279