(a) The output video signal is affected by the key signal
The output video signal is affected by the key signal when the following effects
are selected. To prevent the signal from being affected, set the DME key source
to Int Key, or choose an appropriate input key signal.
(b) When key processing is done, a different image may appear in
the parts which are removed
The following states result, depending on the selected effect.
Removal with the key can be checked by turning the background on.
Border, Beveled Edge: Added also to the outer side of the cropped video
Trail, Keyframe Strobe: The key signal level of the afterimage portion varies
Lighting: The Lighting effect is applied to the whole picture.
Spotlighting: If BKGD or Both is selected in the <Area Select> group, light
(c) No change in the output video signal for effects which are
applied to key signals only
The following states result, depending on the selected effect.
Removal with the key can be checked by turning the background on.
Crop: The Copy effect is applied to the key signal only. The video signal does
Edge Soft: The Edge Soft effect is applied to the key signal only. The video
Shadow, Flex Shadow, Combine Shadow: The key signal density changes.
Fade: The key signal density changes according to depth data. The video
Key Density: The key signal density changes. The video signal does not
Invert Settings
Inverts the input video signal and/or key signal horizontally or vertically. You
can make separate settings for the front and back.
650
DME Special Effect Operations
Page Turn, Roll, Cylinder, Sphere, Spotlighting, global effects (Combiner,
Brick, Shadow)
signal.
with adjustments of the knob (Decay), but the afterimage portion of the
video signal does not disappear until Trail Eraser (KF Strobe Eraser) is
turned on or the effect is turned off.
strikes the entire background.
not change.
signal does not change.
The video signal does not change.
signal does not change.
change.