Advertisement
the two card frames between the front and back frames.
6— 32x5/16" machine screws at each end of each card frame.
and back frames have slotted holes allowing the card frames to be
adjusted slightly when the Mother board is installed on the base
plate and boards are inserted in the card frames.
The self-adhesive rubber feet can then be separated from each other,
the protective backing removed, and placed on the bottom of the
cabinet spaced 3 inches along the left hand and right hand edge of
the bottom, to support the cabinet weight.
BASE PLATE HOLE IDENTIFICATION
The base plate currently being shipped is a universal base plate,
with extra holes for accomodating two styles of mother board mount
ing systems and two styles of power supplies.
and mother board systems shipped with your kit:
1.
Place the Power Supply p.c. board in the base plate cavity
and line up the holes in the p.c. board with the correspon
ding holes in the base plate and mark (e.g., with a felt-
tip pen) which holes are to be used.
2.
The mother board mounting system uses the two rows of 12
holes each on the left side of the base plate.
SWITCH ESCUTCHEON INSTALLATION
When the CP-A Front Panel Assembly has been mounted, the Switch
Escutcheon {piece A2B) can be installed on the base plate at the
front of the computer using four 6-32x5/16" Phillips pan head machine
screws.
Note that the Escutcheon should fit under the base
plate.
CABLE CLAMP INSTALLATION
Cables that do not fit the connector holes on the back frame of the
chassis may be clamped for strain relief at the top of the back
frame using the L - shaped aluminum bar, piece K.
two 6-32xV' Phillips pan head machine screws.
thickness of the cables being clamped, either of the two sides of
the angle may be used.
TABLE TOP COVER INSTALLATION ■
To install the table top cover, slide the cover carefully over the
chassis frame and hold in place with four 6 - 3 2 x V Phillips pan head
machine screws.
Refer to Appendices for an exploded
1
2
IMSAI 8080 System
Cabinet Assembly Instructions
For the power supply
Install using
Depending on the
view of the chassis cabinet.
Use two
The front
Advertisement
