Advertisement
28)
The smallest heat sink is used near the bottom of
the bpard, closest to the edge connector.
the
screw and lockwasher through the regulator
# 6
and heat sink and tighten with the nut on the back
side of the board.
two remaining heat sinks and solder each of the regu
lator leads, in place.
screw in order to prevent shorting to adjacent traces.
29)
Add jumper wires for desired address onto the jumper
header.
(See User Guide Section).
the address of the board.
30)
A)
Using clipped resistor leads (or bus wire) to
select 0 wait states, jumper hole (C) to
hole (
).
0
B)
For one wait state, jumper hole (C) to hole
,
(1)•
These holes are located on the board
directly below locations D2 and D3.
31)
The select interrupt jumper may be installed after
reading the User Guide Section and after determining
which vectored interrupt is desired.
RAM 4A
Assembly Instructions
Repeat this procedure with the
NOTE: Be sure to hold the
JUMPER OPTIONS
Insert
This indicates
6 - 1 5
Advertisement
