Advertisement
ASSEMBLY INSTRUCTIONS
1. Unpack your board and check all parts against the
( )
parts list enclosed in the package.
2. If gold contacts on the edge connector appear to
( )
be corroded, use pencil
oxidation.
abrasive material as it will remove the gold
plating.
3. Insert and solder the five 36K Ohm, h watt
( )
(orange, blue, orange) resistors at locations Rl,
R 4 , R24, R43 and R44 as shown on the Assembly
Diagram.
4. Insert and solder the twenty IK Ohm, h watt
( )
black, red) resistors at locations R2, R3, R5, R6,
R17, R18, R20, R22, R23, and R31 through R41 as
shown on the Assembly Diagram.
5. Insert and solder the two 1.2K Ohm, h watt (brown,
( )
red, red) resistors at locations R9 and R15 as
shown on the Assembly Diagram.
6. Insert and solder the three 470 Ohm, h watt (yellow,
( )
violet, brown) resistors at locations RIO, R12 and
R29 as shown on the Assembly Diagram.
7. Insert and solder the six 10K Ohm, h watt (brown,
( )
black, orange) resistors at locations Rll, R19,
R21, R25, R26, and R42 as shown on the Assembly
Diagram.
( )
8. Insert and solder the two 100 Ohm, h watt (brown,
black, brown) resistors at locations R27 and R28
as shown on the Assembly Diagram.
9. Insert and solder the one 220 Ohm, h watt (red, red,
( )
brown) resistor at location R30 as shown on the
Assembly Diagram.
( )
10. Insert and solder the one 330 Ohm, h watt (orange,
orange, brown) resistor at location R14 as shown on
the Assembly Diagram.
11. Insert and solder the one 56 Ohm, % watt (green,
( )
blue, black) resistor at location R7 as shown on
the Assembly Diagram.
eraser to remove any
NOTE: Do not use Scotchbright or any
RESISTOR INSTALLATION
Assembly Instructions
(brown,
1 - 2 9
Advertisement
