Advertisement
Both the Photographic mask and the paper backup sheet
should be trimmed to size after . assembly. Marks are.
provided on both, and they should be cut out carefully
using a straight edge and a very sharp knife against
a wooden cutting board.
line is first drawn on the sheets.
assembly screws should be cut out on the mask and the
paper sheet as indicated in the diagram.
protective paper may be removed from the two acrylic
sheets and the sandwich assembled carefully.
getting dush caught in between any of the pieces.
soft lint-free rag very slightly moistened can be an
aid in cleaning any dust off plastic or file surfaces.
When the acrylic pieces, film and paper have been
assembled, eight 7/16 inch spacers may be slipped over
the screws and then the whole assembly inserted through
the mounting holes on the CP-A board.
there is no interference from any component standing too
high and that the acrylic panels sit down completely on
the 7/16 inch spacers against the board.
Eight % inch spacers can then be slipped over the screws
behind the CP-A board and eight #6 nuts and lockwashers
can be put on to hold the sandwich together.
The panel board should now be ready to plug in and use.
If the board is going to be assembled in the front
location of a cabinet, to serve as a permanent front
panel, the eight nuts should be removed at this time.
Install the cap screws in the PEM nuts in the front panel
sheet metal.
4 - 2 2
CP-A Rev. 4
Assembly Instructions
Scissors may be used if a guide
The 8 holes for the
Take care that
Then the
Avoid
A
Advertisement
