Roll Media Option Specifications - Oce Arizona 200 GT User Manual

Roll Media Option Specifications

Introduction
The Roll Media Option available for the Arizona 200/250 GT printer allows the use
of various flexible media that are supplied on a roll. Specifications such as print
speed, print area available and the amount of waste associated with the use of roll
media are indicated in this section.
Note: The Arizona 200/250 GT and the Roll Media Option must be operated in
accordance with the environmental conditions specified in the Arizona 200/250 GT
Site Preparation Guide and all safety requirements noted in this document.
Media Size Supported
Width (Max.): 2.2m (86.6")
Width (Min.): 0.9mm (36")
Roll Diameter (Max.): 240mm (9.45")
Core Inner Diameter: 76.2mm (3")
RMO Print Speeds
For printers with software/firmware greater than version 2.6, RMO print speeds are
approximately as shown in this table.
[33]
RMO Print Mode
Production
Quality
Quality Matte
Quality Density
Fine Art
Print Size Supported
2.190m (86.2")
This allows for a minimum 5mm (0.2") border. This is necessary to ensure the platen
is not contaminated with ink due to possible media tracking errors. Cured and
uncured ink on the platen will have a serious effect on printer performance. Any
spilled ink must be removed immediately (See RMO Maintenance section). If an
image exceeds the 5mm border requirement, printing will not be allowed to proceed.
Arizona 250 GT
m /hr. / f /hr.
13.1 / 141
9.4 / 101
6.6 / 71
5.0 / 54
7.3 / 78
Roll Media Option Specifications
Arizona 200 GT
m /hr. / f /hr.
7.3 / 78
5.1 / 55
N/A
N/A
3.9 / 42
103