How To Remove The Rubber Protector - GRAPHTEC GL2000 User Manual
Midi logger hv
Hide thumbs
Also See for GL2000:
- Quick start manual (24 pages) ,
- Setup manual (16 pages) ,
- User manual (202 pages)
Table of Contents
Advertisement
CHAPTER 2 Checks and Preparation
How to remove the rubber protector
(1) Open the upper and lower corner of the Rubber Protector on one side of this device as shown below.
(2) Push out the body from the back side.
(2)
(1)
(3) When both corners of this device are removed from the Rubber Protector, pull the protector over the
terminal block.
(3)
(4) Remove the body completely from the Rubber Protector.
2-6
Advertisement
Table of Contents
