GRAPHTEC GL2000 User Manual page 62

(9) START/STOP (USB Drive Mode)
USB Drive Mode
In the "USB Drive Mode", check the internal memory and SD card as external storage devices on the PC.
They will be recognized as two external storage media.
Transfer and delete files since two external storage media are recognized as a removable disk.
1. Using a USB cable, connect to the PC.
2. To enter the USB Drive Mode, press down [START/STOP] key from when the power is turned on until the
display below appears.
3. The external storage media is recognized by the PC and data exchange becomes possible.
* In USB Drive Mode, the display on this device becomes as follows:
•
To exit USB Drive Mode, turn off and turn on the power again .
•
During USB Drive Mode, no operation including data capture and data replay is available .
•
USB memory does not conform to USB Drive Mode .
This key performs the following two operations:
<Starts/stops capture>
• During Free Running, starts capture.
• During capture, stops capture.
CHAPTER 3 Settings and Measurement
3-21