How To Detach The Rubber Protector; How To Attach The Rubber Protector - GRAPHTEC GL2000 User Manual
Midi logger hv
Hide thumbs
Also See for GL2000:
- Quick start manual (24 pages) ,
- Setup manual (16 pages) ,
- User manual (202 pages)
Table of Contents
Advertisement
CHAPTER 2 Checks and Preparation
2 .5 How to detach the rubber protector
How to attach the rubber protector
To remove the battery pack, first remove rubber protector.
(1) Insert one side of this device about half into the Rubber Protector.
(2) Pull the cover over the terminal block and insert the remaining half.
(3) Adjust so that the rubber protector is not out of position.
(4) Make sure that the corners and convexities are properly fitted and adjust the protector so that there is no
gap.
2-5
Advertisement
Table of Contents
