GRAPHTEC GL2000 User Manual page 129

CHAPTER 3 Settings and Measurement
(3)-3 XY display
Setting
Display mode
CH
Trace
Position
Vernier
Span Upper limit
Lower limit
Zero point
Origin
Execute
Clear waveform at the start of
recording.
XY display clear
XY Overwrite Select File
Overwrite clear
CH (X-axis/Y-axis CH setting)
Set X-axis and Y-axis of XY graph.
You can select from among analog CHs.
Trace
Set the trace of XY waveform.
XY-CH which trace is set to Off is not displayed on the graph and the digital display.
3-88
Set the display mode of the screen.
Y-T, Y-T (full screen), Logging, XY
Set the X- axis and Y- axis of XY graph.
CH1 to CH4
Set the trace of XY graph.
Off, On
Waveforms are not displayed on the screen when trace is Off. Also they are not displayed on
the digital display.
Set the XY position.
0% to 100%
Set the XY vernier.
40 to 100%
* The range depends on the range setting.
Set the span.
You can set it when the analog CH in the Span mode is set on the axis.
Automatic zero adjustment of the analog CH set to the X-axis and Y-axis is performed.
Set the origin position in the Y graph.
Center, Lower left
Initialize the XY position to the set origin.
Set the enable or disable of XY waveform clearing at the start of capturing.
Off, On
Perform the XY waveform clear manually.
Select the image file to be overwritten and then perform the overwriting.
The XY overwrite is cleared and completed.
Description