GRAPHTEC GL2000 User Manual page 103

CHAPTER 3 Settings and Measurement
(1)-5 Other settings
< Voltage/Humidity >
< Temperature >
Setting
object
DC (1) Annotation Settings
RMS
(2) Inter-CH Op Settings
TEMP
RH
(3) Span Settings
(4) Set waveform color
(5) Line Thickness Setting
(6) Trace
DC (7) Perform Auto Zero ADJ.
RH
(8) Reset Auto Zero ADJ.
(9) Set Zero Point as
RMS (10) RMS value operation cross
(11) Get current measured voltage
(12) Cross value reset
RH (13) Burnout check
Calculation between CHs settings
Setting
(1) Inter-CH Op
(2) Operation
3-62
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(1)
(2)
(3)
(4)
(5)
(6)
(13)
Setting
value
value
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
Off, On
If this setting is ON, the channel has a calculation mark in the digital display, etc.
Calculation mark
Set the calculation formula. Set right-hand side CH, left-hand side CH and operator.
The result of calculation is reflected in the set CH.
Right-hand side CH (Operator) Left-hand side CH
Right-hand side CH, Left-hand side CH: CH1 to CH4
Operator: +, -, ×, /
The values assigned to the right-hand side CH and left-hand side CH are the measured
values before the calculation. You cannot change the value after calculation.
CH-X (Function) CH-Y
< Effective value (RMS) >
Set the annotation (comment) displayed in the CH.
Set rule for calculation between channels.
Four arithmetic operations (+, -, x, ÷) can be set as calculation between
channels.
Set the upper limit of the span displayed in the Y-T waveform.
Set the display color of each CH. 0 to 31 for each of red, green, blue (RGB)
Set the line thickness (1 to 8 dots).
Set the waveform display to On or Off.
The current input voltage (RH) is calculated as a zero point voltage value
(zero point RH value).
Reset the zero point voltage value (zero point RH value).
The zero point voltage value (zero point RH value) is displayed.
Set the voltage where is the ± cross value for performing the RMS operation.
The RMS operation cross value of (10) is calculateed automatically from the
current input waveform.
Reset the RMS operation cross value. (Set to 0V.)
Check the disconnection of the thermocouple.
Description
(1)
(2)
(3)
(4)
(5)
(6)
(10)
(11)
(12)
Description