Acceleration/Deceleration Stop Function - Omron M1 Series User Manual

5 Basic Settings
5-6-3

Acceleration/Deceleration Stop Function

• This function causes the inverter stop accelerating/decelerating temporarily and start running at a
constant speed at the frequency output at that time.
• There are two acceleration/deceleration stop methods as follows, which can be used in conjunction
with each other.
• When the output frequency reaches the set frequency, acceleration/deceleration stops for the set
stop time.
• Stop the acceleration/deceleration operation by entering "163: HLD (Acceleration/deceleration
stop)" in Input Terminal [DI1] Function Selection to Input Terminal [DI7] Function Selection (E01
to E05, E98, E99).
Parameter
No.
E103
E104
E105
E106
E01 to E05,
E98, E99
• If the HLD terminal is ON, acceleration/deceleration operation stops regardless of the stop time. Un-
til the set stop time elapses, acceleration/deceleration stops continuously even if the HLD terminal is
turned OFF during the set stop frequency.
Stopping when the specified frequency/stop time is reached
• Set the frequency at which acceleration operation is stopped to E103, and set the time that acceler-
ation operation is stopped to E104. To not stop acceleration operation, set Acceleration Stop Time
(E104) to 0.0.
• Set the frequency at which deceleration operation is stopped to E105, and set the time that deceler-
ation operation is stopped to E106. To not stop deceleration operation, set Deceleration Stop Time
(E106) to 0.0.
5-42
Function name
Acceleration Stop
0.00 to 590.0
Frequency
Acceleration Stop
0.0 to 60.0
Time
Deceleration Stop
0.00 to 590.0
Frequency
Deceleration Stop
0.0 to 60.0
Time
Input Terminal
[DI1] Function Se-
lection to Input
163: HLD (Acceleration/deceleration stop)
Terminal [DI7]
Function Selec-
tion
Output
frequency
E105
E103
Data
E106
E104
Time
M1 Series Standard Type User's Manual (I669)
Default data Unit
0.00 Hz
0.0 s
0.00 Hz
0.0 s
- -