Flow Of Test Run - Omron M1 Series User Manual

3-3

Flow of Test Run

Perform a test run of the inverter according to the following flow.
Item
Installation
Wiring and connections
Power-on
Display status checks
Parameter initialization
Parameter setting
No-load run
Load run
Operation
M1 Series Standard Type User's Manual (I669)
Description
Install the inverter according to the installation
conditions.
Connect the inverter to the power supply and pe-
ripheral equipment.
Check the points mentioned in the next page be-
fore turning the power supply ON.
Check that no error is occurring on the inverter.
Initialize inverter parameters.
Set the parameters required for the test run.
Run the motor in a no-load state via Digital Opera-
tor.
Operate the inverter via Digital Operator with the
mechanical system connected.
Basic settings (operation by the basic settings re-
quired to operate and stop the inverter)
Vector control (operation using vector control and
other functions)
3 Operation and Test Run
Reference
2-1-1 Inverter Installation on
page 2-2
2-3 Wiring on page 2-10
3-4 Operation Items for Test Run
on page 3-18
Section 9 Troubleshooting on
page 9-1
5-1 Display and Initialization on
page 5-3
5-3 Motor Parameter Settings on
page 5-19
5-4 RUN command on page
5-25
3-1 Operation of Operator on
page 3-2
3-1 Operation of Operator on
page 3-2
Section 5 Basic Settings on
page 5-1
Section 6 Vector Control and
Applied Functions on page
6-1
3
3-17