Operation Of Operator; Part Names And Descriptions - Omron M1 Series User Manual

3 Operation and Test Run
3-1

Operation of Operator

The Operator is a display operation panel for the 3G3M1 Series Inverter.
3-1-1

Part Names and Descriptions

The table below shows the name and function of each part of the Operator.
USB connector
PRG/RESET key
Display
3-2
LED
Enter key
Name
Error LED
Program LED
RUN LED
Monitor LED (Hz)
Monitor LED (A)
x10 LED
Data display
RUN command LED
indicator
LED (top right)
RUN key
STOP key
Description
Lights (red) when the inverter trips.
For how to reset a trip error state, refer to How to Reset a Trip
State on page 9-2.
Lights (green) when editable data (set value) is displayed on
the data display.
Lights (green) when the inverter is running (during output to
the motor). Lights during deceleration after RUN command
OFF. Goes out while the RUN command is ON at Frequency
Reference 0 Hz as there is no output (excluding Zero Speed
Control).
Lights (green) when a frequency value is displayed on the da-
ta display.
Lights (green) when a current value is displayed on the data
display.
This x10 LED lights (green) when the displayed data exceeds
9999. "Currently displayed data x 10" is the actual data.
Displays (in red) various data such as a parameter value, fre-
quency value, or set value.
Lights (green) when the Run command is set to Digital Oper-
ator, and flashes (green) when the
forced operator function.
(This indicates that the key is enabled on the Digital Op-
erator.)
Starts inverter operation. Note that this key is enabled when
the RUN command is set to Digital Operator.
Stops the inverter (deceleration stop).
M1 Series Standard Type User's Manual (I669)
Data display
RUN key
Increment key
STOP key
Decrement key
key is enabled by the