Omron M1 Series User Manual page 382

5 Basic Settings
Parameter
Set data
No.
6
98
99
6
97
0
1
2
E01 to
3
E05, E98,
173
E99
174
175
176
177
178
179
10
159
8
*1. "98: FW (forward rotation)" and "99: RV (reverse rotation)" can be allocated to only Input Terminal [DI6]
Function Selection (E98) or Input Terminal [DI7] Function Selection (E99). When one function has been allo-
cated to two terminals, the state is considered to be ON by both terminals turning ON.
2nd Control Function (SET)
On the M1 series, two controls are held in two parameters. There are three types of parameters:
shared parameters, parameters for 1st control and parameters for 2nd control. Parameters for 1st con-
trol and parameters for 2nd control are switched for to use.
• To enable switching to the 1st and 2nd control, allocate "12: SET (2nd control)" to either of input ter-
minal [DI1] to [DI7]. (OFF: 1st control, ON: 2nd control)
• The status of the selected control can be checked via external output terminals by allocating "49:
SETM (2nd control under selection)" to Output Terminal [DO1] Function Selection (E20), Output
5-52
Fig. 2: Example of response time matching less than
twice and non-recognition of inverter ON
Input Terminal [DI1]
Input Terminal [DI1] Response Time (H324)
Function name
SET (2nd control)
*1
FW (forward rotation)
*1
RV (reverse rotation)
STP (3-wire stopping: NC contact)
F/R (3-wire forward/reverse rotation)
CF1 (Multi-step speed setting binary
1)
CF2 (Multi-step speed setting binary
2)
CF3 (Multi-step speed setting binary
3)
CF4 (Multi-step speed setting binary
4)
SF1 (Multi-step speed setting bit 1)
SF2 (Multi-step speed setting bit 2)
SF3 (Multi-step speed setting bit 3)
SF4 (Multi-step speed setting bit 4)
SF5 (Multi-step speed setting bit 5)
SF6 (Multi-step speed setting bit 6)
SF1 (Multi-step speed setting bit 7)
JG (Jogging)
2CH (2-step acceleration/decelera-
tion)
RS (Reset)
Reference item
2nd control
Forward run command
Reverse run command
3-wire input function
Multi-step speed operation
function
Jogging
2-step acceleration/decelera-
tion
Reset
M1 Series Standard Type User's Manual (I669)
Reference
page
page
5-55
page
5-56
page
5-57
page
5-60
page
5-66
page
5-66