Table of Contents
Advertisement
1
Overview, Installation, and Selection of Probing Options
The E5402A-Pro Series Low-profile Right-angle 34-channel
Single-ended Soft Touch Probe
E5402A-pro series low-profile
right-angle 34-channel
single-ended
soft touch probe
14
(for analyzers with 90-pin cable connectors)
The Agilent E5402A- pro series probe is a 34- channel,
single- ended, soft touch probe compatible with the Agilent
logic analysis modules listed in
capable of capturing data up to the rated maximum state
(synchronous) analysis clock rates of all the supported
analyzers, with signal amplitudes as small as 250 mV
peak- to- peak. A retention module must be installed on the
target system board to attach the probe to the board. There
is a key on the retention module that indicates the egress of
the cable when the probe is attached.
A kit of five retention modules are supplied with each
probe. Refer to
"Ordering retention modules"
information on ordering more.
See
"Mechanical Considerations"
information on designing your target system board.
Figure 2
E5402A-pro series right-angle single-ended soft touch probe
and E5412A retention module
Table 1
on page 19 for
E5412A retention
module
E5400-Pro Series Soft Touch User's Guide
on page 12. It is
on page 13 for
Cable egress
key
Hide quick links:
Advertisement
Table of Contents
