Table of Contents
Advertisement
the LAN.
If you are using a site LAN you should be able to ping both the logic analysis
system and the emulation probe.
If you are using a point-to-point LAN connection you must use a special
crossover LAN cable, such as the one supplied with the emulation module.
The telnet window of the logic analysis system should be able to communicate
with the emulation probe. This window can be found by selecting the "System
Admin" icon in the main system window.
• Check that the emulation probe is connected to the emulation module
with the module/probe interconnect cable.
If this cable is connected, you should be able to display the firmware version
from the "Update Firmware" window.
• Check that you have the proper processor support package installed.
You can check this by selecting the System Admin icon in the main system
window, then looking at the list of software packages installed.
• Test the emulation module. See page 102.
• Test the emulation probe. See page 103.
• Try using the Setup Assistant to configure your measurement setup.
Step 5: Check your debugger connection
If you are using a debugger, try connecting to the emulation probe.
If you have problems using the emulation probe
with a debugger
Most problems are associated with not having the emulation probe and target
properly configured or initialized.
Some debuggers have an initialization file that needs to be properly defined
before a debugger can connect to the emulation probe.
• Make sure the PC or workstation where the debugger is running can
E5900B / E5901B User's Guide Supplement
Troubleshooting the Emulator
Troubleshooting Guide
89
Advertisement
Table of Contents
Troubleshooting
