Page 1
Check Point 600 Appliances Quick Start Guide Includes Check Point Software Blades...
Page 2
Power Up Check Point 600 Appliance • Connect the power cable to the power port on the 600 Appliance rear panel. Plug the power supply unit into a power outlet. • The Power LED on the front panel will light, indicating that the appliance is turned on.
Page 3
For ADSL Models: • Connect the included telephone cable to DSL port on the 600 Appliance rear panel and plug it into ADSL line socket. • DSL Link LED on the front panel will light when connection is established. Important Note: you must have a microfilter connected to each socket on the line the ADSL is enabled on, even if you will not connect the ADSL modem to that socket.
Page 4
Instruction for Microsoft Windows: On Windows* 7: • – Click > Control Panel > Network and Sharing Center. Click “Local Area Connection.” – • On Windows 8: – On your desktop, go to Apps > Control Panel > Network and Internet >...
Page 5
Configure Your Check Point 600 Appliance • Launch the Web browser and type http://my.firewall or https://192.168.1.1:4434 in the address bar. Note – You might receive a certificate error page since the appliance does not have a formally signed certificate. Click “Continue to this Web site.”...
Page 6
License page by clicking the “Activate License” button (click “Set proxy” to configure proxy settings if needed). Your device will automatically contact and register itself with the Check Point User center, providing it has been configured with Internet access.
Need help?
Do you have a question about the 600 and is the answer not in the manual?
Questions and answers