Figure 4.15 Qos Ingress Port Policer - Advantech EKI-8500 Series User Manual

Item
Ingress Map
Egress Map
Save
Reset
4.3.4.2 Port Policing
This function allows you to configure the Policer settings for all switch ports.
1. Navigate to Configuration > QoS and click Port Policing.
The QoS Ingress Port Policer page displays.
The following table describes the items in the previous figure.
Item
Port
Enable
Rate
Unit
Flow Control
Save
Reset
4.3.4.3 Queue Policing
This function allows you to configure the Queue Policer settings for all switch ports.
1. Navigate to Configuration > QoS and click Quene Policing.
EKI-8500 Series User Manual
Description
Enter the string to indicate the ID for the Ingress Map (range: 0 to
255). An empty field indicates no map selection.
Enter the string to indicate the ID for the Egress Map (range: 0 to 511).
An empty field indicates no map selection.
Click Save to create a new user account.
Click Reset to clear the settings.

Figure 4.15 QoS Ingress Port Policer

Description
Displays the port number for the entry.
Click to enable or disable (default) the port policer for the port.
Enter the string to indicate the control rate of the port policer (values:
10 to 13128147 for kbps, 1 to 13128 Mbps/fps/kfps).
Click the drop-down menu to select the measurement unit. Options:
 kbps
Mbps

 fps
 kfps
Click to enable or disable (default) flow control mode.
If flow control is enabled and the port is in flow control mode, then
pause frames are sent instead of discarding frames.
Click Save to create a new user account.
Click Reset to clear the settings.
45