Figure 4.10 System Log Configuration - Advantech EKI-8500 Series User Manual

The following table describes the items in the previous figure.
Item
Daylight Saving Time Click the drop-down menu to select disable (default), recurring, non-
Start Time Settings
End Time Settings
Offset Settings
Save
Reset
4.3.1.5 Log Configuration
The System Log provides server mode operations. When the mode is enabled, a
syslog message is sent to the syslog server. The syslog protocol is based on UDP
communication and received on UDP port 514. The syslog server will not send
acknowledgments back sender since UDP is a connectionless protocol and it does
not provide acknowledgments. The syslog packet are sent out even if the syslog
server does not exist.
To configure System Log, access the page as follows:
1. Navigate to Configuration > System and click Log.
The System Log Configuration page displays.
The following table describes the items in the previous figure.
Item
Server Mode
Server Address
Syslog Level
Save
Reset
EKI-8500 Series User Manual
Description
recurring.
Disabled

 Recurring: the configuration repeats every year
 Non-Recurring: A single time configuration
Enter the Month, Date, Year, Hours, and Minutes to setup start time.
Enter the Month, Date, Year, Hours, and Minutes to setup end time.
Enter the number of minutes to add during Daylight Saving Time
(Range: 1 to 1439).
Click Save to store the settings.
Click Reset to clear the settings.

Figure 4.10 System Log Configuration

Description
Click the drop-down menu to enable or disable (default) the server
mode function.
Enter the IPv4 host address of the syslog server. If DNS is featured, a
domain name can be indicated.
Click the drop-down menu to indicate the type of message:
 Error: Send a specific message(s) if the severity code is less or
equal than Error (3).
 Warning: Send a specific message(s) if the severity code is less
or equal than Warning (4).
 Notice: Send a specific message(s) if the severity code is less or
equal than Notice (5).
 Informational: Send a specific message(s) if the severity code is
less or equal than Informational (6).
Click Save to store the settings.
Click Reset to clear the settings.
37