Table of Contents
Advertisement
Item
Enable
Rate
Unit
Save
Reset
The following table describes the items in the Port Storm Policer Configuration figure.
Port storm policers for all switch ports are configured on this page.
Item
Port
Enable
Rate
Unit
Save
Reset
4.3.5
TSN
4.3.5.1
PTP Check
When using TAS and PSFP between network elements, it is required to have a
common global time reference provided by PTP. When booting the device, it will take
some time for a configured PTP application to get locked to the common time
reference. It may cause malfunctioning of TAS and PSFP if config-change is issued
EKI-8500 Series User Manual
Description
Click to enable or disable (default) the global storm policer for the
given frame type.
Enter the string to indicate the rate for the global storm policer (value:
10 to 13128147 fps or kbps, and 1 to 13128 kfps or Mbps). Supported
rates are divisible by 10 fps or 25 kbps.
Click the drop-down menu to select the unit of measure for the global
storm policer rate (value: fps, kfps, kbps or Mbps).
Click Save to save changes.
Click Reset to undo any changes made locally and revert to
previously saved values.
Figure 4.30 Port Storm Policer Configuration
Description
Displays the port number for the configuration below applies.
Click enable or disable (default) the storm policer for this switch port.
Enter the string to indicate the rate for the port storm policer (value: 10
to 13128147 fps or kbps, and 1 to 13128 kfps or Mbps). Supported
rates are divisible by 10 fps or 25 kbps.
Click the drop-down menu to select the unit of measurement for the
port storm policer rate (value: fps, kfps, kbps or Mbps).
Click Save to save changes.
Click Reset to undo any changes made locally and revert to
previously saved values.
57
Advertisement
Table of Contents
