Wall-Mounting; Figure 2.3 Removing The Din-Rail - Advantech EKI-8500 Series User Manual

2.3.1.2 Removing the DIN-Rail Mounting Kit
1. Push the switch down to free the bottom of the plate from the DIN rail.
2. Rotate the bottom of the device towards you and away from the DIN rail.
3. Once the bottom is clear of the DIN rail, lift the device straight up to unhook it
from the DIN rail.
\
2.3.2

Wall-Mounting

The wall mounting option provides better shock and vibration resistance than the DIN
rail vertical mount.
Note! When installing, make sure to allow for enough space to properly install
the cabling.
Before the device can be mounted on a wall, you will need to remove the DIN rail
plate.
1. Rotate the device to the rear side and locate the DIN mounting plate.
2. Remove the screws securing the DIN mounting plate to the rear panel of the
switch.
3. Remove the DIN mounting plate. Store the DIN mounting plate and provided
screws for later use.
4. Align the wall mounting plates on the rear side. The screw holes on the device
and the mounting plates must be aligned, see the following illustration.

Figure 2.3 Removing the DIN-Rail

12
DIN Rail
EKI-8500 Series User Manual