Accessing The Cli; Web Browser Configuration; Preparing For Web Configuration - Advantech EKI-8500 Series User Manual

– parameter will specify the parameter within the section. For example, the net-
work section will have parameters for DHCP, IP address, subnet mask, and
default gateway.
– value is the new value of the parameter. If value is omitted, the current value
is displayed.
Please note that new values will not take effect until explicitly committed.
Sections and parameter names are case sensitive (e.g., "Network" is not the same as
"network").
Note!
Any commands in the CLI Commands section of this chapter, with the
exception of the global commands, must be prefaced with the name of
the section they are in. For example, to change the IP address of the
switch, you would type:
network address <newIP>
3.2.2

Accessing the CLI

The command-line interface (CLI) is the primary user interface used to configure,
monitor and maintain the devices. It allows you to directly execute CLI commands.
After initially configuring and connecting the device to the network, you can configure
the device by using the remote access method. The following console settings with
default:
Baud rate speed 115200

Databits 8 bits

Parity - none

Stop bits 1 bits

Connect the EKI-8510G to a terminal or to a "COM" port of PC by using terminal
emulation. Press any key or call up the Command Line Interface via Telnet. Press
any key to continuye and enter the user name and password as below with default,
the screen will displays.
User name: admin

Password: admin

3.3

Web Browser Configuration

The switch has an HTML based user interface embedded in the flash memory. The
interface offers an easy to use means to manage basic and advanced switch func-
tions. The interface allows for local or remote switch configuration anywhere on the
network.
The interface is designed for use with [Internet Explorer (10.0), Chrome, Firefox].
3.3.1

Preparing for Web Configuration

The interface requires the installation and connection of the switch to the existing net-
work. A PC also connected to the network is required to connect to the switch and
access the interface through a web browser. The required networking information is
provided as follows:
IP address: 192.168.1.1

Subnet mask: 255.255.255.0

Default gateway: 192.168.1.254

User name: admin

Password: admin

28 EKI-8500 Series User Manual