Table of Contents
Advertisement
3.
Once selected, click Start Upgrade to begin the process.
After the software image is uploaded, a page announces that the firmware update is
initiated. After about a minute, the firmware is updated and the switch restarts.
Warning! While the firmware is being updated, Web access appears to be
defunct. The front LED flashes Green/Off with a frequency of 10 Hz
while the firmware update is in progress. Do not restart or power off the
device at this time or the switch may fail to function afterwards.
4.5.3.2
Image Select
The page provides information about the active and alternate (backup) firmware
images in the device, and allows you to revert to the alternate image.
1.
Navigate to Maintenance > Software and click Image Select.
The Software Image Selection page displays.
The following table describes the items in the Software Image Selection page.
Item
Image
Version
Date
Active Alternative
Image
Cancel
4.5.4
Configuration
4.5.4.1
Save startup-config
Note!
The generation of the configuration file may be time consuming,
depending on the amount of non-default configuration.
Figure 4.61 Software Upload
Figure 4.62 Firmware Selection
Description
Displays the name of the firmware image since its last update.
Displays the version of the firmware image.
Displays the production date of the firmware.
Click Activate Alternative Image to use the alternate image. This
button may be disabled depending on system state.
Click Cancel to discontinue activating the backup image. Returns to
the previous page.
82
EKI-8500 Series User Manual
Advertisement
Table of Contents
