Figure 4.7 Configuring Ip Settings - Advantech EKI-8500 Series User Manual

Item
Delete
Network
Mask Length
Gateway
Next Hop VLAN
(IPv6)
Distance
Add Route
4.3.1.3 NTP Configuration
To configure NTP, access the page as follows:
Navigate to Configuration > System and click NTP.
1.
The NTP Configuration page displays.
The following table describes the items in the previous figure.
Item
Mode
Server 1 / 5
Save
Reset
4.3.1.4 Time Zone Configuration
To configure Time Zone Configuration, access the page as follows:
1. Navigate to Configuration > System and click Time.
EKI-8500 Series User Manual
Description
Click Delete to remove the specified route entry.
Enter the destination IP network or host address of the route. The
following values denotes a default route: 0.0.0.0 or IPv6 ::.
Enter a value to define the IP network or host mask in number of bits
(prefix length). Valid values are between 0 and 32 bits (128 for IPv6
routes). Only a default route has a mask length of 0.
Enter the IP address of the IP gateway. The gateway and Network
must be of the same type.
Enter the IPv6 to specify the interface associated with the gateway.
Range: 1 to 4094. The range is valid only when the corresponding
IPv6 interface is valid. Link-local addresses, must specify the next hop
VLAN. If the IPv6 gateway address is not link-local, the system
ignores the next hop VLAN for the gateway.
Enter a value to specify the next hop distance for the route.
Click Add Route to add a route entry.

Figure 4.7 Configuring IP Settings

Description
Click the drop-down menu to select the operation mode:
 Enabled: Enable NTP client mode operation.
 Disabled: Disable NTP client mode operation.
Enter the IPv4 or IPv6 address of an NTP server. For IPv6 addresses,
enter a 128-bit record represented as eight fields of up to four
hexadecimal digits with a colon (:) separating each field.
Click Save to store the settings.
Click Reset to clear the settings.
35