Replacing A Fip Module - H3C SR6604 Installation Manual

Figure6-4 Pulling the MCP out of the slot
4. If you do not install a new MCP in the slot, install a filler panel. To install a new MCP, see
"Installing an MCP

Replacing a FIP module

1. Determine the FIP module to be removed. This section takes the FIP module in slot 3 as an
example.
2. Loosen the captive screws of the FIP module until all spring pressure is released.
3. Holding the ejector levers of the FIP module with both hands, pull the ejector levers outward,
and gently pull the FIP module out of the slot along the slide rails.
Figure6-5 Pulling the FIP module out of the slot
MPU."
61