Installing An Interface Module - H3C SR6604 Installation Manual

Figure2-21 Assembling a MIC-X adapter module and a MIC interface module into a MIC-X
interface module
1
3
5

Installing an interface module

The installation procedure is the same for HIM, MIM, MIC, and MIC-X interface modules.
To install a HIM/MIM/MIC/MIC-X interface module:
1. Locate the slot to install the target module on the FIP module.
2. Loosen the captive screws on the filler panel, and then remove the filler panel.
Keep the filler panel safe for future use.
3. Use even pressure to push the module slowly along the slide rails into the slot, and then close
the levers.
Install a HIM/MIM/MIC-X with the components upward and install an MIC with the components
downward.
Gently push the MIC interface
module circuit board into the MIC-X
adapter module
24
2
4
6