Replacing An Ssd Drive; Replacing A Sap/Oap/Switching Fabric Module - H3C SR6604 Installation Manual

4. If you do not install a new FIP module in the slot, install a filler panel. To install a new FIP
module, see

Replacing an SSD drive

Before you remove an SSD drive, remove the service module from the router. For the removal
procedure of service modules, see
fabric module."
To remove an SSD drive:
1. Use a Phillips screwdriver to remove the fastening screws on the SSD drive.
2. Gently lift the SSD drive free from the connector and slightly pull the SSD drive out of the slot.
Keep the SSD drive secure.
3. Install a new SSD drive. For the installation procedure, see
Figure6-6 Removing an SSD drive

Replacing a SAP/OAP/switching fabric module

CAUTION:
When the RUN LED of the SAP/OAP/switching fabric module is fast flashing, do not remove the
module.
To replace a SAP/OAP/switching fabric module:
1. Determine the SAP/OAP/switching fabric module to be removed. This section takes the SAP
module in slot 3 as an example.
2. Loosen the captive screws of the SAP module until all spring pressure is released.
3. Holding the ejector levers of the SAP module with both hands, pull the ejector levers outward,
and gently pull the SAP module out of the slot along the slide rails.
"Installing a FIP module and an air
"Replacing a FIP
deflector."
module" or
1
3
62
"Replacing a SAP/OAP/switching
"Installing an SSD drive."
2