Replacing An Rse-X1 Mpu; Replacing An Mcp - H3C SR6604 Installation Manual

4. Install a new RPE-X1 MPU. For more information, see
RPE-X1/RPE-X3/RPE-X5/RPE-X5E

Replacing an RSE-X1 MPU

1. Determine the MPU to be removed. This section takes the MPU in slot 1 as an example.
2. Loosen the captive screws of the MPU until all spring pressure is released.
3. Holding the ejector levers of the MPU with both hands, pull the ejector levers outward, and
gently pull the MPU out of the slot along the slide rails.
Figure6-3 Pulling the RSE-X1 MPU out of the slot
4. If you do not install a new MPU in the slot, install a filler panel. To install a new MPU, see
"Installing an RSE-X1

Replacing an MCP

To replace an MCP, for example, MCP-X1:
1. Determine the MCP to be removed. This section takes the MCP in slot 1 as an example.
2. Loosen the captive screws on the MCP until all spring pressure is released.
3. Holding the ejector levers of the MCP with both hands, pull the ejector levers outwards, and
gently pull the MCP out of the slot along the slide rails.
MPU."
MPU."
60
"Installing an