Installing A Cf Card; Installing A Power Module - H3C SR6616 Installation Manual

Figure 25 Pushing the fan tray into the slot
Power on the router and check the status LED on the front panel.
3.
On means the fan tray is operating correctly. Off means the fan tray has failed the POST. For
the LED description of the fan tray, see

Installing a CF card

To install a CF card on an MCP, remove the CF card cover first.
To install a CF card:
Push the CF card eject button all the way into the slot, and make sure the button does not
1.
project from the panel.
Insert the CF card into the slot following the direction shown in
2.
not project from the slot.
Figure 26 Inserting the CF card into the slot
NOTE:
If the boot file of the router is stored in the CF card, before booting the router, make sure the CF card
has been correctly installed. Otherwise, the router cannot be booted.

Installing a power module

The procedures for installing an AC power module and DC power module are the same. The
following uses a PSR650-A AC power module as an example.
Locate the slot to install the power module. Use even pressure to gently push the power module
1.
slowly along the slide rails into the slot.
"Fan tray LEDs."
29
Figure 26, and make sure it does