Connecting An E1/T1 Cable - H3C SR6604 Installation Manual

Figure4-15 8E1 splitter cable
BNC
NOTE:
The coaxial connector and 75-ohm E1 adapter cable are optional accessories, and must be
purchased separately if needed.
T1 cable
You can use an 8T1 interface cable to connect to MIM-8T1/MIM-8T1-F modules.
Figure4-16 8T1 splitter cable
RJ45

Connecting an E1/T1 cable

Connecting an E1 cable (D15/D68 <----> BNC)
CAUTION:
When connecting the interface cable, pay attention to the mark on the interface to avoid wrong
insertion, which might damage the interface module or even the router.
•
If you do not need to extend the cable, you can directly connect the BNC connectors of the E1
75-ohm cable to the remote network device as follows.
a. Connect the D15/D68 connector of the E1 75-ohm cable to the D15/D68 interface of the
interface module and fasten the bolts to fix the cable.
DB68
DB68
45