Table of Contents
Advertisement
Figure 16 Push the MIM into the slot
Use a flat-blade screwdriver to fasten the captive screws on the MIM.
Step3
Power on the router and check the status LED on the front panel. On means the MIM is installed correctly
Step4
and running properly. Off means the MIM has failed the POST.
NOTE:
HIMs are hot swappable and you must perform the remove slot
before you remove it.
Installing a CF card
Follow these steps to install a CF card:
Make sure that the CF card status LED is not flashing.
Step1
Push the CF card eject button all the way into the slot, and make sure that the button does not project from
Step2
the panel.
Insert the CF card into the slot following the direction shown in
Step3
project from the slot.
Figure 17 Insert the CF card into the slot
number
Figure
16
command to stop the module
17, and make sure it does not
Advertisement
Table of Contents
