H3C SR6604 Installation Manual page 31

Hide thumbs Also See for SR6604:

Table of Contents

MIC-X adapter module components

Figure2-18 Screw

M3 screw × 4

Figure2-19 Carrier

Figure2-20 Front panel

Assembling a MIC-X adapter module and MIC interface module into a MIC-X interface module

Use a screwdriver to remove the four screws from the MIC interface module circuit board so

that the front panel and the gasket are disengaged from the circuit board.

Align the MIC interface module circuit board with the guide rails on the MIC-X adapter module

carrier. Gently push the circuit board into the carrier along the guide rails until the circuit board

makes close contact with the connectors on the MIC-X adapter module carrier.

Install M3 screws provided with the MIC-X adapter module carrier into the two screw holes at

the center of MIC interface module circuit board and fasten the screws.

Select the front panel matching the MIC interface module, align the front panel with the ports on

the circuit board, and use M3 screws to attach the front panel to the circuit board.

The MIC-CLP2L, MIC-CLP4L, MIC-SP4L, MIC-SP8L, MIC-ET16L interface modules can be

assembled into corresponding MIC-X modules by using MIC-X adapter modules.

Table of Contents

Sr6608