Replacing A Transceiver Module - H3C SR6604 Installation Manual

Figure6-10 Pressing the eject button to eject the CF card
4. Install a new CF card. For more information, see
To protect the CF card, place it into an antistatic bag.

Replacing a transceiver module

WARNING!
• Do not stare into the optical fibers.
• When removing a transceiver module, do not touch the golden finger of the transceiver module.
The replacement procedure is the same for LC and MPO transceiver modules. The LC transceiver
module is used as an example in this procedure:
1. Remove the optical fibers from the transceiver module.
2. Pivot the clasp down to the horizontal position.
3. As shown in Figure6-11, holding the handle of the transceiver module, gently pull the
transceiver module out.
4. Insert the plastic plug to the removed transceiver module, and put the transceiver module into
its original shipping materials.
5. If you do not install a new transceiver module in the interface, install a dust-proof plug in the
interface. To install a transceiver module, see
Figure6-11 Removing a transceiver module
"Installing a CF
"Connecting a fiber
65
card."
cable."