Installing An Rse-X1 Mpu - H3C SR6604 Installation Manual

Hide thumbs Also See for SR6604:

Table of Contents

Figure2-10 Inserting the RPE-X1 into the slot

Fasten the captive screws on the RPE-X1.

Observe the RUN LED on the RPE-X1 to verify that the RPE-X1 is installed correctly.

After the router is powered on, the RUN LED on the RPE-X1 flashes green at 8 Hz until the

application software is loaded. When the RUN LED flashes green at 1 Hz, the RPE-X1 is

operating correctly.

NOTE:

When two RPE-X1 or RPE-X3 MPUs are installed on the router, the ACT LED on the active

MPU is steady green. For the MPU LED descriptions, see H3C SR6604[6608] Routers

Hardware Information and Specifications.

Installing an RSE-X1 MPU

Locate the slot to install the RSE-X1.

You can install an RSE-X1 in slot 1 or slot 2. This procedure uses slot 1 as an example.

Loosen the captive screws on the filler panel in slot 1, and then remove the filler panel.

Use even pressure to gently push the RSE-X1 into slot 1 along the slide rails, and then push the

ejector levers inward to lock the RSE-X1 in position.

Table of Contents

Sr6608