Replacing A Him/Mim/Mic/Mic-X - H3C SR6604 Installation Manual

Figure6-7 Pulling the SAP module out of the slot
4. If you do not install a new SAP module in the slot, install a filler panel. To install a new SAP
module, see

Replacing a HIM/MIM/MIC/MIC-X

CAUTION:
To avoid hardware damage, do not install or remove a HIM/MIM/MIC/MIC-X module when the RUN
LED on a FIP module is fast flashing green.
IMPORTANT:
After you remove a HIM/MIM/MIC/MIC-X from a FIP, the HIM/MIM/MIC/MIC-X settings will not
automatically restore if you reinstall the HIM/MIM/MIC/MIC-X on the FIP after the FIP reboots. To
save the settings, make sure the HIM/MIM/MIC/MIC-X is in position before rebooting the FIP module
or inserting the FIP module into the router.
IMPORTANT:
A MIC-X-ET16-compatible FIP module supports only one MIC-X-ET16 assembled by a MIC-X
adapter module and a MIC-ET16L interface module.
The replacement procedures for HIMs, MIMs, MICs, and MIC-Xs are similar.
To replace a HIM/MIM/MIC/MIC-X:
1. Determine the HIM/MIM/MIC/MIC-X to be removed, and completely loosen the captive screws
of the HIM/MIM/MIC/MIC-X.
2. Fully open the ejector levers on the HIM/MIM/MIC/MIC-X. Hold the ejector levers and then
gently pull the HIM/MIM/MIC/MIC-X out of the slot along the slide rails.
The ejector levers of the FIP module are long. When removing the HIM/MIM/MIC/MIC-X in slot
1 on the FIP module, avoid touching the right ejector lever of the FIP module.
"Installing a SAP/OAP/switching fabric module."
63