Table of Contents
Advertisement
9.
Connect all peripheral cables to the server.
10. Connect each power cord to the server.
11. Connect each power cord to the power source.
12. Power up the server.
The installation is complete.
After installing the DIMMs, use the System Utilities > System Configuration > BIOS/Platform Configuration (RBSU) >
Memory Options to configure the memory settings.
Installing the FlexibleLOM adapter option
Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure
1.
Power down the server.
2.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3.
Disconnect all peripheral cables from the server.
4.
Do one of the following:
•
Extend the server from the rack.
•
Remove the server from the rack.
5.
Remove the access panel.
6.
If an expansion board is installed in the primary riser, do the following:
a. Disconnect the cables from the expansion board.
b. Remove the primary riser cage.
7.
Remove the FlexibleLOM blank.
84
Hardware options installation
Advertisement
Table of Contents
